For my part, I will have several fresh equipment builds on display + for purchase, including guitar, home hi-fi, and recording studio equipment, plus, for the first time, tons of LP records, vintage audio equipment, and general antique audio flotsam+jetsam. I’ll be passing the time hand-building… something, I’m not sure yet, but probably some sort of esoteric vacuum-tube mic preamp.
Full details are available here.
I’ll be posting another reminder the week of the event.
This month on Preservation Sound Radio: nine side-filling tracks from 1970 thru 1986, all from…
This month's show airs Tuesday 2.20.24 at 8:30PM -11:25PM EST on WPKN 89.5 FM in…
The first Preservation Sound Radio program of 2024 will air Tuesday January 16 at 8:30PM…
As aired 8:30PM-11:30PM 12.19.23 on WPKN 89.5 FM Bridgeport. Enjoy. PSR DEC2023 sequence 1. Click…
Tonight 11.21.23 8:30 PM EST: special advance broadcast of the P/S Winter 2024 Mixtape. Catch…
Here's the tracklist for the 2023 Preservation Sound Summer Mixtape, to be broadcast 8:30PM EST…
View Comments
Here's a pretty good project that might be something you can morph to what you want:
http://www.radioworld.com/article/curt%E2%80%99s-gyraf-audio-g-tube-mic-project/221879
Audio engineers the world over appreciate the sound of vintage tube microphones like the Neumann U 47 or the AKG C12, but the cost can easily run to several thousand dollars, leaving them beyond the reach of all but the biggest studios (or well-heeled dilettantes). What if I were to tell you that, for under $600 — and with a bit of labor — you could enjoy a taste of that vintage sound?
Looks like up your alley....
haha if u think i am about to build that thing, you overestimate me... but thanks! I would be up for DIYing a tube mic, if there was a reliable recipe for doing so by re-building an existing FET condensor, EG., an oktava 319...
Just buy a capsule from one of several suppliers and build the boards.
The case can be made from any of several metals. Surely in Bridgeport, Ct. there is someone who will do the metalwork!
A ribbon mic is an easier project in some ways. It's inherently low impedance so the amp does not have o be in the mic body.
I personally think a GOOD FET mic would be as good as a tube one if you didn't have phantom power to dick with. David Manley had a discussion with me on this.